KA-6130 Front Panel Header?
Part of my Proteva project: I was stupid and forgot to note the settings for the front panel header when I removed them. Well I sort of did but forgot to label where the positive ones went. Apparently on the first try I plugged in everything right except the HD LED, which worked before. (The power LED which was always broken, still didn't work, so I figured the LED was dead.) I was trying to find info about this motherboard online to see what the FP header diagram looked like but I haven't found anything. It's a FIC KA-6130, Slot I Pentium II board with a 100MHz FSB.
On a side note: I wasn't sure the speed on the ATA controller on the board either... if the FSB is set at 100 MHz, that means that it's ATA/100?
On a side note: I wasn't sure the speed on the ATA controller on the board either... if the FSB is set at 100 MHz, that means that it's ATA/100?
Comments
http://en.wikipedia.org/wiki/Parallel_ATA
But as far as I am aware FSB does not directly affect signalling rate of any ATA/IDE interfaces.
And @nkkigreg1974: I've seen that manual already and yet it included no information or diagrams relating to the board schematic itself. It didn't show what the power headers were supposed to be...