It looks like you're new here. If you want to get involved, click one of these buttons!
Read the full story here
This was fun (not) to install under VMware.
It turns out that the INSTALL disk (or SETUP disk if you are using a different source) really doesn't like the VMware IDE hard drive emulation.
If you use that, the installation floppy's boot code simply ends up rebooting infinitely.
If you try a SCSI HD instead, you will go through all the (quite horrible) installtion process only to find that in the end the MS-DOS 4 SCSI driver installed on the HD doesn't play well - executing 'illegal' SCSI instructions, or something.
In the end I started from scratch and used the VMware SATA HD emulation: Pay dirt! The installation process worked, and I could finally boot into a HD-based full installation of MS-DOS 4.0. What a rigmarole!
@BigAlUK Brilliant! Thanks for the comment, I had the same issue.
@JoeSzup Your welcome
I would remind anyone trying to run this of a few things. 1: MS-DOS 4.0 was so buggy that it taught a lot of people to never trust a "X.0" release. 2: It had so many issues, a lot of people stayed with 3.x until after the release of MS-DOS 5.0. So if you have problems, you would not be the only one.